Alumax ProLine PL70 Manual de instruções de instalação - Página 6

Procurar online ou descarregar pdf Manual de instruções de instalação para Invólucro Alumax ProLine PL70. Alumax ProLine PL70 8 páginas. Heavy frameless bypass bath enclosure

Imprimir página

Door Panel – Notice that the Roller [O] has an offset

attachment plate. Install the Rollers to the Door Glass [P]

with the Plastic Washer [Q]against the Roller and the Roller

Bushing [R] against the Roller Cap [S]. Adjust the roller so that

the hole in the attachment plate is to the left or right. This will

allow adjustment after the door has been installed. Snug it

down firmly, but not all the way, using a 5/64" Allen wrench to

hold the roller and the adjustable wrench to turn the cap. Install

your handle option at this time. Set the door glass inside the

enclosure with the rollers to the outside. CAUTION: Make sure

that you set the Door Glass on something so that the glass

and/or the floor of the enclosure is not damaged. Cardboard

packing material works fine.

Load the Bar – Place the Fixed Panel [E] on a flat surface

with the mounting holes hanging off the edge, and the

inside of the panel facing down. Thread a Glass Mount Screw

[T] through an Inner Glass Mount Retainer [U], through the

middle hole in the Header Bar [D], through a metal Glass Mount

Spacer [V] and a Small Plastic Washer. Insert the end of the

screw through the hole 1 ½" from the edge of the Fixed Panel

[E]. Place the Glass Insert [X] over the end of the screw and into

the hole in the glass. Place a Large Plastic Washer [Y] and a

Glass Mount End Cap [Z] over the end of the screw and snug

the assembly. (DO NOT TIGHTEN). Do the same for the other

Glass Mount. Place a Stopper [AA] on each end of the Header

Bar with the rubber bumper to the top and facing towards the

middle of the Header Bar. Slide the Stopper over 6" or so from

the end and snug a Stopper Set Screw [BB] to keep it from

moving freely. (DO NOT TIGHTEN). Slide a Wall Mount Sleeve

[CC] on both ends of the Header Bar with the set screw hole

closest to the edge of the sleeve facing the end of the bar, and

snug one Set Screw [DD]. (DO NOT TIGHTEN).

Page 7 of 9