Fleck 7000SXT Manual de instalação - Página 6

Procurar online ou descarregar pdf Manual de instalação para Controlador Fleck 7000SXT. Fleck 7000SXT 17 páginas.

Brine tank assembly

 Brine tank

installation

instructions

1. The float assembly is a safety float; it only functions if there is a failure in the control valve. This will insure

that the brine tank won't over flow with water. The safety float DOES NOT dictate the water level in your

brine tank.

2. Measure 10" from the top of the air check valve (shown as #1 in figure 3 below) to the bottom of the float

(shown as #2 in figure 3 below). You may have to gently push the float rod through the rubber gametes to

achieve this, cut any existing rod off.

3. Slide the float assembly into the brine well (shown in figure04 below) and stick the stud into the side hole

on the brine well ( shown in figure 5). Be sure to secure it with the nut we supplied you.

Page 6 of 17

Make sure you have all of the pieces to the brine assembly. The nuts and

ferrules are now combined into one and are usually already attached to the

brine assembly; please check this to make sure.

Figure 3

Fleck 7000 SXT

http:// www.Qualitywatertreatment.com