Blueshape Energy inside PWS-RUGGED Manual de Instruções - Página 8
Procurar online ou descarregar pdf Manual de Instruções para Gerador portátil Blueshape Energy inside PWS-RUGGED. Blueshape Energy inside PWS-RUGGED 16 páginas. Power station for v-lock and 3-stud lithium ion batteries only
Imprimir página
Explanation of the DC outputs
1.
Two outputs are available at all times -
(always available) and a regulated 28V or 48V (user selectable)
2.
A total of 6 x XLR outputs are installed on the PWS-RUGGED
side panel. These are divided as 2 sockets for each voltage (ie:
in parallel)
3.
The 28V and 48V are each splitted on 2 x 3-pin female XLRs
4.
The 14V is always available on 2 x 4-pin female XLRs
5.
The 28V or 48V are alternative and user selectable through a
switch. When 28V is selected, the 48V output is disabled. If 48V
is selected, the 28V output is disabled
6.
If there is an overload on any of the 3 different outputs, all the
outputs are automatically disconnected and the yellow RESET
button is lit. To reactivate the device, the user needs to remove
the overload condition and then press the RESET button
7.
The instant power released from the 14V and 28V~48V output
is always shown on the display
Properties of the PWS-RUGGED
-
Powerful 28V/48V selectable @ 20A/10A and 14V/24A
continuous output capability
-
High speed charging of 4 batteries simultaneously at 4A (65W)
-
Heavy duty, water resistant, rugged design. Ideal for harsh
outdoor environments
-
5V twin USB output for charging mobile devices
-
Sophisticated internal electronics with highly efficient DC-DC
converters and the acclaimed BLUESHAPE 'QUICKCHANGER'
technology featuring on all 4 channels for hot swapping of
batteries.
-
Can operate with as little as one battery on board (though not
recommended since the unit will not be able to reach its full
performance capabilities)
-
Accurate data display obtained by the direct dialogue between
unit and the batteries (BLUESHAPE batteries only)
8
-
Data communication outlet (useful for firmware upgrades/
testing and calibration purposes at factory or even for future
user software applications)
a regulated 14V