Auber Instruments WS Series Руководство по эксплуатации и инструкция - Страница 6

Просмотреть онлайн или скачать pdf Руководство по эксплуатации и инструкция для Контроллер Auber Instruments WS Series. Auber Instruments WS Series 18 страниц. Programmable pid temperature controller with dual probe
Также для Auber Instruments WS Series: Краткое руководство (15 страниц), Краткое руководство (14 страниц), Руководство по эксплуатации и инструкция (18 страниц), Краткое руководство (14 страниц)

Figure 5. How to remove the sensor.

2) Operating the controller

3.1 Setting the temperature.

Press SET key twice. Both 1) and 2) will start to flash. The LED shows the current

temperature setting. Use "+" and "-" keys to change the setting. When finished, press the

SET again to confirm the change.

Note: the temperature setting will not be changed if SET is not pressed (confirmed). The

display will return to the normal display mode if no key is pressed within 3 seconds.

3.2 Switching the display between temperature and time.

This is done by pressing the Time Key "6)" once. When "8)" is on (lit) and "9)" is flashing

at the same time, the LED is in timer mode and shows the actual time passed since the

controller was last powered on. When "8)" is off (not lit), the LED is in temperature mode

and shows the current sensor temperature.

3.3 Setting the timer.

Press SET key once and release it, both "1)" and "8)" will start flashing. The LED shows

the current timer setting in minute. Use the "+" and "-" keys to change the timer setting.

When finished, press the SET again to confirm the change.

Note: the timer setting will not be changed if SET is not pressed (confirmed). The display

will return to the normal display mode if no key is pressed within 3 seconds.

Using the timer The timer can be used in two different ways.

a) Use it as timer. If you set the timer for 1200 minutes, the controller will stop sending

power to the cooker 1200 minutes after it is powered up. It will display "End" on the