Auber Instruments WS Series Руководство по эксплуатации и инструкция

Просмотреть онлайн или скачать pdf Руководство по эксплуатации и инструкция для Контроллер Auber Instruments WS Series. Auber Instruments WS Series 18 страниц. Programmable pid temperature controller with dual probe
Также для Auber Instruments WS Series: Краткое руководство (15 страниц), Краткое руководство (14 страниц), Руководство по эксплуатации и инструкция (18 страниц), Краткое руководство (14 страниц)

Introduction

Thank you for purchasing the Auber WS series temperature controller. We sincerely

appreciate your decision and trust that our machine will meet your expectations in both

the quality of the result and the value of our product. While we are delighted that you may

be anxious to operate the controller for your project, a few minutes of your time reading

through this manual will only serve to enhance your experience in the months and years

ahead. In particular, we urge you to read through the safety warnings below. Although

this plug-and-play controller is very easy to operate, the process involves high

temperature and high wattage appliances, and your safety is paramount.

 This controller is designed only to be used with devices that have limited power

and their own thermal cut off protection, such as a thermostat or thermal fuse in

case of controller failure.

 Do not place any objects on the top of controller surface which is used to vent

excess heat during its operation.

 The maximum electric current this controller can handle is 15 ampere. For 120

volt AC in US and Canada, this limits the heater power to1800 watts. Due to its

compact size and the splash proof design for kitchen applications, the controller

has a limited ability to dissipate the heat generated by the internal solid state relay

during the initial heat up. The initial full power heat up process cannot be more

than 90 minutes. If you system need take longer time to warm up, please read

Appendix 1 "Managing the heat generated by the controller"

 Always place the sensor in the controlled subject when the controller is on.

Before turning on the controller, please make sure the sensor is placed inside the

container to be controlled. Leaving the sensor outside will form an open loop

Operation Instruction Manual

WS-1500ES

Precision PID Temperature Controller

Version 1.4

Auber Instruments

5755 North Point Parkway, Suite 99

Alpharetta, GA 30022

770-569-8420

www.auberins.com

Dec, 2016

SAFETY WARNINGS