Auber Instruments WS Series Руководство по эксплуатации и инструкция - Страница 5

Просмотреть онлайн или скачать pdf Руководство по эксплуатации и инструкция для Контроллер Auber Instruments WS Series. Auber Instruments WS Series 18 страниц. Programmable pid temperature controller with dual probe
Также для Auber Instruments WS Series: Краткое руководство (15 страниц), Краткое руководство (14 страниц), Руководство по эксплуатации и инструкция (18 страниц), Краткое руководство (14 страниц)

The connection of the controller should be done in the following steps.

 Plug the temperature sensor to the back of the controller.

 Plug the power cord to the power outlet on the wall.

 Turn on the controller to make sure the controller powers up properly and the

temperature display is in the range expected. Then, turn off the controller.

 Plug the heater to the back of the controller. If the heater has a switch, put it in the

off position. Put the sensor inside the container to be controlled.

 Turn on the controller.

 Turn on the heating device.

Remark The connector of sensor contains a slot for correct pin connection. It also has a

spring lock to prevent disconnections from accidental pulling on the cable. The following

pictures show how to install and remove it.

Fig 3a. How to install the sensor.