DYNACO 79-001 Руководство по установке - Страница 2

Просмотреть онлайн или скачать pdf Руководство по установке для Стереосистема DYNACO 79-001. DYNACO 79-001 6 страниц. Hifi hospital, original replacement pcb

Печатать страницу

The following steps require the use of a soldering iron. In the following steps, disconnect the

wires at the PCB end only, after unsoldering, bend wires away from PCB to avoid burning the

wire insulation with soldering iron. Avoid sharp bends to prevent breaking wire. (If wires appear to

be brittle, it is highly recommended that they be replaced with pre-tinned #20-#22AWG stranded

wire).

( ) Using a soldering iron, disconnect wire connected to eyelet #11 on PCB.

( ) Using a soldering iron, disconnect wire connected to eyelet #12 on PCB.

( ) Using a soldering iron, disconnect wire connected to eyelet #13 on PCB.

( ) Using a soldering iron, disconnect wire connected to eyelet #14 on PCB.

( ) Using a soldering iron, disconnect wire connected to eyelet #6 on PCB.

( ) Using a soldering iron, disconnect wire connected to eyelet #7 on PCB.

( ) Using a soldering iron, disconnect wire connected to eyelet #1 on PCB.

( ) Using a soldering iron, disconnect wire connected to eyelet #2 on PCB.

( ) Using a soldering iron, disconnect wire connected to eyelet #5 on PCB.

( ) Using a soldering iron, disconnect wire connected to eyelet #4 on PCB.

( ) Using a soldering iron, disconnect 10 ohm (brown, black, black) resistor

connected to eyelet #8 on PCB.

( ) Using a soldering iron, disconnect wire connected to eyelet #3 on PCB.

( ) Using a soldering iron, disconnect wire connected to eyelet #19 on PCB.

( ) Using a soldering iron, disconnect wire connected to eyelet #20 on PCB.

( ) Using a soldering iron, disconnect wire connected to eyelet #21 on PCB.

( ) Using a soldering iron, disconnect wire connected to eyelet #15 on PCB.

( ) Using a soldering iron, disconnect wire connected to eyelet #16 on PCB.

( ) Using a soldering iron, disconnect wire connected to eyelet #9 on PCB.

( ) Using a soldering iron, disconnect 10 ohm (brown, black, black) resistor

connected to eyelet #10 on PCB.

( ) Using a soldering iron, disconnect wire connected to eyelet #17 on PCB.

( ) Using a soldering iron, disconnect wire connected to eyelet #22 on PCB.

( ) Using a soldering iron, disconnect wire connected to eyelet #23 on PCB.

( ) Using a soldering iron, disconnect wire connected to eyelet #18 on PCB.

( ) Using a pair of wire cutters/ strippers, disconnect two (2) remaining wires connected to PCB,

cut wires as close to the PCB as possible (these wires will be reconnected to the new PCB).