DYNACO 79-001 설치 지침 매뉴얼 - 페이지 2

{카테고리_이름} DYNACO 79-001에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DYNACO 79-001 6 페이지. Hifi hospital, original replacement pcb

페이지 인쇄
DYNACO 79-001 설치 지침 매뉴얼
The following steps require the use of a soldering iron. In the following steps, disconnect the
wires at the PCB end only, after unsoldering, bend wires away from PCB to avoid burning the
wire insulation with soldering iron. Avoid sharp bends to prevent breaking wire. (If wires appear to
be brittle, it is highly recommended that they be replaced with pre-tinned #20-#22AWG stranded
wire).
( ) Using a soldering iron, disconnect wire connected to eyelet #11 on PCB.
( ) Using a soldering iron, disconnect wire connected to eyelet #12 on PCB.
( ) Using a soldering iron, disconnect wire connected to eyelet #13 on PCB.
( ) Using a soldering iron, disconnect wire connected to eyelet #14 on PCB.
( ) Using a soldering iron, disconnect wire connected to eyelet #6 on PCB.
( ) Using a soldering iron, disconnect wire connected to eyelet #7 on PCB.
( ) Using a soldering iron, disconnect wire connected to eyelet #1 on PCB.
( ) Using a soldering iron, disconnect wire connected to eyelet #2 on PCB.
( ) Using a soldering iron, disconnect wire connected to eyelet #5 on PCB.
( ) Using a soldering iron, disconnect wire connected to eyelet #4 on PCB.
( ) Using a soldering iron, disconnect 10 ohm (brown, black, black) resistor
connected to eyelet #8 on PCB.
( ) Using a soldering iron, disconnect wire connected to eyelet #3 on PCB.
( ) Using a soldering iron, disconnect wire connected to eyelet #19 on PCB.
( ) Using a soldering iron, disconnect wire connected to eyelet #20 on PCB.
( ) Using a soldering iron, disconnect wire connected to eyelet #21 on PCB.
( ) Using a soldering iron, disconnect wire connected to eyelet #15 on PCB.
( ) Using a soldering iron, disconnect wire connected to eyelet #16 on PCB.
( ) Using a soldering iron, disconnect wire connected to eyelet #9 on PCB.
( ) Using a soldering iron, disconnect 10 ohm (brown, black, black) resistor
connected to eyelet #10 on PCB.
( ) Using a soldering iron, disconnect wire connected to eyelet #17 on PCB.
( ) Using a soldering iron, disconnect wire connected to eyelet #22 on PCB.
( ) Using a soldering iron, disconnect wire connected to eyelet #23 on PCB.
( ) Using a soldering iron, disconnect wire connected to eyelet #18 on PCB.
( ) Using a pair of wire cutters/ strippers, disconnect two (2) remaining wires connected to PCB,
cut wires as close to the PCB as possible (these wires will be reconnected to the new PCB).
2