Autopilot APCET Инструкции - Страница 2

Просмотреть онлайн или скачать pdf Инструкции для Контроллер температуры Autopilot APCET. Autopilot APCET 4 страницы.

Basic Description

The APCET is a temperature controller that can be used as a

Cooling OR a Heating controller. Once the APCET is connected

to a power source, and the cooling or heating device is connected

to the APCET power outlet, the device connected will be

automatically controlled by the settings on the APCET.

The user can choose to have different Day and Night temperature

settings which will be automatically switched to the correct mode

by the built-in photocell. The knobs make it easy to adjust the

settings and provide a quick visual verification of the current set-

points. The LEDs on the front of the unit will turn ON and OFF to

show the user the current conditions of the APCET.

NOTE: This unit is water-resistant however...

Keep it away from water!!! It is NOT WATER PROOF.

Installation

Plug the unit into a standard NEMA 5-15 wall outlet. A 120 volt

power supply is required. For more permanent installations, the

mounting tab at the top of the unit can be secured to a wall.

Ensure that the device being connected to the APCET has the

proper voltage and will not exceed the maximum amperage rating

of this unit. Connect the device to be controller into the power

outlet on the front of the unit.

NOTE: If you are trying to control multiple devices, a

power expansion module can be used to increase the

amount of power load that can be controlled.

DO NOT EXCEED THE MAXIMUM RATING!!!