Autopilot APCET Инструкции - Страница 3

Просмотреть онлайн или скачать pdf Инструкции для Контроллер температуры Autopilot APCET. Autopilot APCET 4 страницы.

Selecting Cooling or Heating Mode

Before using the unit, the user must decide if they are using it for

a Cooling or a Heating control. The 2 knobs on the unit are used

to select the desired mode.

To select Cooling: Connect the unit to power. Rotate both knobs

fully COUNTER-clockwise. After a couple seconds the LEDs on

the front of the unit will start flashing On / Off. After the LEDs stop

flashing, the selected mode is indicated by the LED that remains

illuminated. (*Verify the Cool mode is ON.)

To select Heating: Connect the unit to power. Rotate both knobs

fully clockwise. After a couple seconds the LEDs on the front of

the unit will start flashing On / Off. After the LEDs stop flashing,

the selected mode is indicated by the LED that remains

illuminated. (*Verify the Heat mode is ON.)

* Once the correct mode is selected, the user can now set the

desired temperature settings using the two knobs normally.

Changing Settings

Use the knobs on the front of the unit to adjust the DAY and the

NIGHT temperature settings*. The photocell will automatically use

the correct setting depending on the lighting level. When the

temperature of the area exceeds the temperature set-point, the

device connected to the power outlet will be activated. Since the

temperature control has a dead-band setting of 3

F, the power

outlet will remain activated until the temperature is lowered by 3

degrees F. When the outlet is powered, the Output ON LED will

be ON.

*This example describes the Cool mode. When in Cool mode, the

setting is the maximum temperature of the area to be controlled.

For Heat mode, it is the minimum temperature of the area to be

controlled.