Empire VFD42FB2MF-6 Инструкции по установке и руководство пользователя - Страница 9

Просмотреть онлайн или скачать pdf Инструкции по установке и руководство пользователя для Крытый камин Empire VFD42FB2MF-6. Empire VFD42FB2MF-6 20 страниц. Deluxe universal firebox for all vent-free log sets models

Печатать страницу
Extended Hoods
If your non-combustible facing material is over 1" in thickness that will be used to finish this firebox, an extended hood is available that will
extend out 2" farther out into the room. Contact your local dealer for details.
VB4H32BL
Standard Black
Finishing
All joints (top, bottom and sides), where the wall or decorative facing material meets the firebox surround should be sealed with a non-
combustible material.
Hearth extensions are recommended, but not required for these fireboxes.
The firebox is designed to accept a 3/8-inch gas line for an approved
vent-free gas logset. Have the line installed by a qualified service
person in accordance with all building codes. Consult local building
codes to properly size the gas supply line leading to the 3/8-inch
hook-up at the unit. The state of Massachusetts requires that a
flexible appliance connector cannot exceed three feet in length.
Gas access holes are provided on both sides of the firebox. See
Figure 11. On models with refractory brick panels installed, carefully
remove the knockout in the refractory brick panel using a large
standard screwdriver and hammer. First, place screwdriver in groove
next to plug and pry sideways to pop out main plug. Then remove
the remaining concrete in hole with gentle tapping with ball peen
hammer and/or screwdriver. A masonry drill and bit may also be
used to create a clean hole for the gas line to pass through. See
Figure 12.
When installing optional ceramic fiber side panels into firebox,
lay panel on a flat surface. Remove the gas line knockout (round
depression) in the appropriate side panel using a drill or utility knife.
After the brick panel knockout is removed, the firebox wrap may
have a round metal knockout that must be removed also. Use a
screwdriver to punch out the metal knockout.
Check gas type. Use only the gas type indicated on the gas log
set rating plate. If the gas listed on the plate is not your type of gas
supply, DO NOT INSTALL. Contact your dealer for proper model.
Always use an external regulator for all Propane fireboxes to reduce
the supply tank pressure to a maximum of 14 inch w.c. This is in
addition to the regulator fitted to the log set.
Connection directly to an unregulated propane tank can
cause explosion.
Install only a ANSI Z21.11.2 vent-free log set into this firebox.
39000-2-0820
INSTALLING HOOD
VB4H36BL

GAS LINE CONNECTION

WARNING
Standard Black
VB4H42BL
GAS ACCESS HOLES
NOTE: When installing stainless steel or reflective decorative liner
kits, gas lines must come through the bottom of the firebox.
See Figure 11.
Standard Black
Figure 11
Brick Panel
Figure 12
Page 9