Empire Sniper Руководство пользователя - Страница 6
Просмотреть онлайн или скачать pdf Руководство пользователя для Оборудование для пейнтбола Empire Sniper. Empire Sniper 14 страниц.
Печатать страницу
3. GETTING STARTED
Safety and safe marker handling are the most important aspects of paintball
sports. Please practice each of the following steps with an unloaded marker before
attempting to operate your marker with an air source and paintballs.
• Do not install an air source or load paintballs into your marker until you have
completely read and understood this manual and feel completely confident with
your ability to handle your marker safely.
• Always use ASTM approved paintball specific eye protection. Always wear eye
protection when handling a paintball marker and in any areas where paintball
markers may be discharged.
• Keep your finger out of the Trigger guard and away from the Trigger; point the
muzzle of the marker in a safe direction at all times. Keep the marker in Safe Mode
and use a barrel blocking device.
• Remember that the ultimate safety device is you, the operator.
Safety and Safe Mode
The Safety is a small mechanical
push button on the left side of the
marker above the grips. When the
Safety is "OFF", a red O-ring is visible
on the marker (fig. 3.1). When the
Safety is "ON", the red O-ring will
be hidden and the marker will not
fire (fig. 3.2).
In this manual, you will see the term
"Safe Mode" used. In "Safe Mode",
the Safety should be set to "ON"
(red marking on safety will not be
visible) and a barrel blocking device
should be installed. Make sure your
marker is in "Safe Mode" when the marker is not being fired or when indicated to do so.
2
Barrel Installation
• Make sure marker is degassed, loader removed, no paintballs in the feed port or
breech and the marker is in "Safe Mode".
• Slide the longer barrel tip into the desired barrel back, turning the barrel tip
clockwise until it stops (do not over tighten).
• The barrel backs are sized (.675, .680, .685) to match the paintball diameter to get
the most efficient usage of your Sniper marker.
• While pointing marker in a safe direction, thread the barrel into the front opening of
the marker body.
• Turn the barrel clockwise (when looking at the front opening) until it stops (do not
over tighten).
• Install a barrel blocking device. This can be a barrel bag or other such device that
prevents the accidental discharge of a paintball.
Loader Installation
• To install a loader, check the feedneck and the loader to make sure they are free
from debris and obstructions.
• Press the loader neck into the opening of the feed neck until it stops.
• Align the loader so that the lid is pointing to the rear and the loader is parallel with
the marker.
• Clamp the loader in place by tightening the clamp arm; it may be necessary to
adjust the feed neck clamp screw (see below). Do not over tighten the clamp
holding the loader, as this may damage it.
FIRE - SAFETY "OFF" Fig. 3.1
Feed Elbow Clamp Adjustment
The feed elbow clamp may need adjustment for different types/brands of loaders.
Adjust the thumb nut clockwise to increase the clamping force or counter clockwise
to decrease the clamping force of the lever. No tools are needed to make any
adjustments.
Before Pressurizing your Marker
SAFE - SAFETY "ON" Fig. 3.2
Consult the place where you purchased your Empire marker, or a recognized and
competent air smith, for instruction in the safe handling of compressed-air cylinders
E M P I R E P A I N T B A L L . C O M