Aqua Computer AQUASTREAM XT USB Руководство по эксплуатации и установке - Страница 16

Просмотреть онлайн или скачать pdf Руководство по эксплуатации и установке для Водяной насос Aqua Computer AQUASTREAM XT USB. Aqua Computer AQUASTREAM XT USB 20 страниц.
Также для Aqua Computer AQUASTREAM XT USB: Руководство по эксплуатации (16 страниц)

Печатать страницу

aqua

computer

AQUASTREAM XT

By clicking the button "Reset maximum pump speed", the currently determined

maximum pump speed will be reset and the pump will repeat the start-up process.

The button is effective for both manual and automatic mode.

The parameter "Minimum pump speed" determines the minimum speed for both

automatic and manual mode. If this speed is not attained during start-up, the max-

imum speed detection will be repeated until the minimum speed setting is attained.

If this parameter is set too high, the pump will repeat the start-up process over and

over again – therefore set to a speed at which the pump runs stable.

The parameter "Maximum pump speed" limits the maximum speed in automatic

mode – the pump will not operate faster than this speed even if a higher speed

setting would be possible.

13. Fan configuration (aquasuite)

Select "Fan" from the device list for the device to be configured.

13.1. Fan mode

In the upper area, current fan data (speed, power output, voltage) is displayed as

plain text as well as in a diagram.

Select the desired mode of operation for the fan output below the diagram. If

"Manual fan settings" is selected, the fan output can be set to a fixed value. In

"Automatic temperature control" mode, the fan power will be dynamically adjusted

depending on either the current water temperature sensor reading or an external

temperature sensor.

13.2. Manual fan settings

When using manual mode, set the desired output power here.

13.3. Automatic temperature control

When using the automatic temperature control mode, select the sensor to be eval-

uated and set the desired target temperature. The controller speed setting should

not be changed in normal setups.

13.4. Fan settings

When using the automatic temperature control mode, the output range can be

limited in both directions ("Minimum power"/"Maximum power"). The check box

"Hold minimum power" determines whether the fan will be switched off for low

temperature sensor readings (box not checked) or remain active at the set minim-

um speed (box checked). Set minimum power to a value at which the connected

fan reliably starts up.

- 16 -

Aqua Computer GmbH & Co. KG

Gelliehäuser Str. 1, 37130 Gleichen