A.H. Systems PAM-0118 Руководство по эксплуатации - Страница 5

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Усилитель A.H. Systems PAM-0118. A.H. Systems PAM-0118 13 страниц.

A.H. Systems Model PAM-0118 Pre-Amplifier

Most common causes of failure:

• Excessive power applied to the RF input (such as ESD to the input

• Improper connection sequence (sequence such as application of signals to

• Excessive DC voltage applied

• Storage near strong EMI or RFI fields

• Loose connections causing intermittent events

An over voltage at the preamp input will damage the preamplifier. This type of

damage is without fault of A.H. Systems and will void the warranty.

To connect:

1. Apply DC Voltage

2. Connect output load

3. Apply RF input

To disconnect:

1. Remove RF input

2. Remove load

3. Remove DC voltage

RANGE OF ENVIRONMENTAL CONDITIONS

This equipment is designed to be safe under the following environmental

conditions:

While the equipment will not cause hazardous conditions over this

environmental range, performance may vary.

REV B

connector or antenna connected to the input connector)

the preamplifier before powering up)

Indoor use

Altitude: up to 2 km

Temperature: 5° C to 40° C

Maximum relative humidity: 80% for temperatures up to 31° C.

Decreasing linearly to 50% at 40° C

Pollution degree 2: Normally non-conductive with occasional

condensation.

DC supply voltage fluctuations not to exceed +/- 10% of the nominal

voltage.