Dell DF10MXL Руководство по началу работы - Страница 22
Просмотреть онлайн или скачать pdf Руководство по началу работы для Переключатель Dell DF10MXL. Dell DF10MXL 36 страниц. Networking mxl 10/ 40gbe switch io module
Печатать страницуConnect the USB connector on the cable directly to the switch console port.
The console port on the MXL 10/40GbE Switch is located below the fixed
40GbE ports (Figure 1-4).
Invoking the X-Loader and U-Boot CLIs
During the boot process, you can perform various configuration tasks by
accessing the X-Loader and U-Boot CLIs, such as running memory tests
(X-Loader) and activating the backup image or recovering a password
(U-Boot).
You are first prompted to enter the X-Loader CLI by pressing any key when
the following message displays: Hit any key to stop autoboot. If
you do not press a key, the boot process continues and you are prompted to
enter the U-Boot CLI by pressing any key.
After performing any of the X-Loader or U-Boot tasks, the switch
automatically reboots when you exit a CLI. To continue with the boot process
without entering either CLI, do not press a key.
Performing the Initial Configuration
Prerequisites: Before you perform the initial switch configuration, make sure
that:
•
The MXL 10/40GbE Switch was never configured before and is in the
same state as when you received it.
•
The MXL 10/40GbE Switch booted successfully when it powered on.
Perform the initial switch configuration through the console port. After the
initial configuration, you can manage the switch from the already connected
console port or through a remote connection.
Before you start, to perform the initial switch configuration, you must obtain
the following information from your network administrator:
•
The IP address to be assigned to the out-of-band (OOB) interface for
device management.
•
The IP subnet mask for the OOB interface.
•
The IP address of the OOB interface default gateway.
22
Installing and Configuring the Switch