ACU-RITE 1113777-NN Обновление программного обеспечения - Страница 3

MILLPWR

SOFTWARE

UPDATE

Version (2 or 3 axis) - The version number was updated to R3SP2.

You can download the software release update from our web site at www.acu-rite.com. If you

wish to purchase the software and operation manual from ACU-RITE contact Customer Service

to place an order.

Installing the software onto your MILLPWR

HEIDENHAIN Corporation recommends making a backup of the control with the included USB

Recovery Drive (684138-xx) before updating the control software. Please refer to the manual

included with the drive for the backup procedure.

Use a blank USB memory stick (1 GB or larger) to update the software. Do not use any memory

stick with a smaller storage capacity. The software installation files are required for updating the

software. These files will automatically be recognized by the installation program of the control

and must be contained in a folder named "install" on the USB memory device with typical files

called setup.zip, and setup.ini.

Procedure for updating the software



Shut down the control software using the normal method of pressing the Shutdown soft

key and then confirming the shutdown by pressing Yes.



Wait for the screen message which indicates that it is safe to switch off power, or restart.



Insert the USB memory device containing the folder named "install" on the USB memory

device.



Press ENTER to restart the system.



After starting, the MILLPWR

box. If necessary, use the UP/DOWN ARROW keys to select the language (e.g. English)

and press ENTER.



A confirmation box will appear. If necessary, use the LEFT or RIGHT ARROW keys to

select Yes, and then press ENTER.



The software update will now be done automatically, taking approximately 10 - 20

minutes.



When the update is complete, it will prompt you to remove the USB drive and restart. At

this time, remove the USB drive and press ENTER to restart.



After the system has restarted, it will start up normally to the control software.

If any issues are encountered, please contact your service representative for assistance.

If the USB memory stick used for installation is not removed, then the prompt to install the

software will continue to appear on subsequent power cycles.

system:

Software Update screen will appear with a confirmation