Directed Electronics Xpresskit DBALL Руководство по установке - Страница 7
Просмотреть онлайн или скачать pdf Руководство по установке для Автомобильные аксессуары Directed Electronics Xpresskit DBALL. Directed Electronics Xpresskit DBALL 14 страниц. Databus all combo bypass module
Также для Directed Electronics Xpresskit DBALL: Руководство по установке (14 страниц)
Печатать страницу
Platform: DBALL
Firmware: GM5
Installation Type 4
Driver Door
Sense Trigger
You need to connect these
wires together. These
connections are required for
the module work properly.
* If applicable - see the Function List.
Not required in D2D mode.
The Mobile Integration Systems
Hood Switch
(+) Brake Input
BCM Side
Key Side
6
5
4
3
White or White/Blue
2: Purple/Yellow: J1850
7: Brown
8: Yellow: R. Code (Car Side)
9: Orange/Yellow: R. Code (Key Side)
(+) 12v
13: Red: (+) 12v
(-) Ground
14: Black: (-) Ground
1: Black/White: RAP OFF
3: Green/White: (-) Door Status Output*
5: Violet/White: (AC) Tach Output
8: Violet/Green: R. Code (Car Side)
9: Violet/Brown
(AC) Tach Input
(-) Door Status Input*
(+) Accessory Output
(+) Ignition Output
2
1
Green or Black Connector
located at the ignition switch.
RF Loop Connector
Programming button
DBALL
LED
Vehicle CAN Bus Integration System
Parking Lights
(+) 12 V Input
Ground
(-) Lock Output*
(-) Unlock Output*
(+) Starter Output
(+) Ignition Output
(-) GWR (Status)
1
8
9
16
Diagnostic connector
OBDII (connector side view)
10: Blue/White: (-) GWR (Status) Input
9: Pink: (+) Ignition Input
8: Violet: (+) Starter Input
2: Blue: (-) Unlock Input*
1: Green: (-) Lock Input*
(+)12v
RX
(-) Ground
TX
P#: XKD2D65
© 2010 Directed Electronics. All rights reserved.
Rev.: 20101103
Page 7