aero pure AP80RVL Kurulum Kılavuzu

Fan aero pure AP80RVL için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. aero pure AP80RVL 4 sayfaları. Recessed fan light
Ayrıca aero pure AP80RVL için: Kurulum Kılavuzu (13 sayfalar)

Sayfayı Yazdır

www.aeropurefans.com

WARNING

TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, PLEASE READ THE FOLLOWING:

1.Use this unit only in the manner intended by the manufacturer. If you have questions, contact the manufacturer at the address or telephone number

listed in the warranty. 2.Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent power

from being switching on accidentally. If the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag,

to the service panel. 3. Installation work and electrical wiring must be done by a licensed person(s) in accordance with all applicable codes and

standards, including fire-rated construction codes and standards. 4. Sufficient air is needed for proper combustion and exhausting of gases through

the flue (chimney) of fuel burning equipment to prevent backdraft. Follow the heating equipment manufacturer's guideline and safety standards such

as those published by the National Fire Protection Association (NFPA), and the American Society for Heating, Refrigeration and Air Conditioning

Engineers (ASHRAE), and the local code authorities. 5. When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden

utilities. 6. Ducted fans must always be vented to the outdoors. 7. Acceptable for use over a tub or shower when connected to a GFCI (Ground Fault

Circuit Interrupter) - protected branch circuit. 8. This unit must be grounded. 9. Never place a switch where it can be reached from a tub or shower.

Not for use in kitchens. 11. Install fan at least 2.5 m (8.2 feet) above the floor.

10.

do not use this fan with any solid-state speed control device. 13. The fan must not be installed in a ceiling thermally insulated to a value greater than

R40.

CAUTION

1. For general ventilating use only. Do not use to exhaust hazardous or explosive materials and vapors. 2. This product is designed for installation

in ceilings up to a 12/12 pitch (45 degree angle). Duct connector must be horizontal. ** DO NOT MOUNT THIS PRODUCT IN A WALL.

3. To avoid motor bearing damage and noisy and/or unbalanced impellers, keep drywall spray, construction dust, etc. off power unit. 4. Please read

specification label on product for further information and requirements.

CLEANING & MAINTENANCE

For quiet and efficient operation, long life, and attractive appearance lower or remove grille and vacuum interior of unit with the

dusting brush attachment.

The motor is permanently lubricated and never needs oiling.

OPERATION

Use an on/off switch to operate this fan. See "Connect Wiring" for details

PLAN THE INSTALLATION

. Do not use in a cooking area.

2. Two ways to connect ductwork to a factory-shipped unit

READ AND SAVE THESE INSTRUCTIONS

Installer: Leave this manual with the homeowner

MODEL: AP80RVL

12. WARNING: To reduce the risk of fire or electric shock,

INSULATION*

(Place around and

over Fan Housing.)

POWER

CABLE*

Seal gaps

around

Housing.

ROUND

DUCT*

Purchase

separately

BATHROOM FAN

ROOF CAP*

(with built-in

damper)

FAN

HOUSING

Keep duct

runs short

Seal duct

ROUND

joints with

ELBOW(S) *

tape.

WALL CAP*

(with built-in

damper)