aero pure AP80RVL Kurulum Kılavuzu - Sayfa 2
Fan aero pure AP80RVL için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. aero pure AP80RVL 4 sayfaları. Recessed fan light
Ayrıca aero pure AP80RVL için: Kurulum Kılavuzu (13 sayfalar)
Sayfayı Yazdır
ASSEMBLY INSTRUCTIONS
1. Before installation, you need to know:
Screw A
Screw B
Hanger bar
(long)
1. MOUNT WITH HANGER BARS
1a. Sliding hanger bars have been provided, which allow the housing to
be positioned accurately anywhere between the framing. The bars may
be used on all types of framing: I-joist, standard joist, and truss
construction. Slide hanger bars onto housing and adjust as needed to fit
between framing.
1b. Extend the hanger bars to the width of the framing. Position the
fan with the hanger bar tabs aligned with the bottom edge of the framing,
holding the ventilator in place.
Secure hanger bars to framing using one screw on each end of hanger
bar. Attach set screws to lock bar hangers in place.
2. INSTALL ROUND DUCTWORK
Connect the round ductwork (not included) to the damper/duct connector,
and run the ductwork to a roof or wall cap (not included). Using duct tape
(not included), secure all the ductwork connections so that they are air
tight. Insulated flexible duct is recommended for the quietest possible
installation. A 1 – 3 foot run of rigid duct- followed by insulated flexible
duct- will ensure quietest operation.
CONNECT ELECTRICAL WIRING
Run 120 Volts AC house wiring to the fan. Use only UL-approved connectors (not included) to attach the house wiring to the
wiring plate. Refer to the wiring diagram, and connect the wires as shown.
ST4.2*1/2"
ST4.2*1"
13 3/8"
BLACK(BLK)
BLUE(BLU)
LIGHT
FAN
SWITCH BOX
POWER SUPPLY
120V AC
2
14 3/8 in.-23 1/2 in. (365-597)
Screw A
Screw B
WHITE(WHT)
GROUND (GRD)
UNIT
WIRE PANEL
FAN
LIGHT
RECEPTACLE RECEPTACLE
Aero Pure AP80RVL