aero pure AP80RVL Kurulum Kılavuzu - Sayfa 3

Fan aero pure AP80RVL için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. aero pure AP80RVL 4 sayfaları. Recessed fan light
Ayrıca aero pure AP80RVL için: Kurulum Kılavuzu (13 sayfalar)

Sayfayı Yazdır

FINISH CEILING WORK

1. A round ceiling hole 6 1/2 inches (165mm) diameter should be cut.

Seal any gap between the hole in the drywall and the fan with sealant.

2. Install the compact florescent bulb or LED bulb. Bulb not included.

3. The bulb housing can adjust up or down to accommodate different

bulbs. Unit is qualified with use of G24 adaptor and use of a GU24

bulb.

REPLACEMENT INSTALLATION

1. Remove the trim ring by detaching the springs.

2. Remove the screws as shown in the right.

3. Remove the lamp base.

4. Pull the duct system so that you can see the blower

system.

REPLACEMENT INSTALLATION

5. Remove the screws as shown on the right.

6. Remove the blower system from of the housing.

7. Replace the broken parts.

REPLACEMENT INSTALLATION

8. To replace the capacitance remove the wire panel, and then

replace the capacitance.

READ AND SAVE THESE INSTRUCTIONS

Installer: Leave this manual with the homeowner.

Fluorescent lamp

Joist

Hanger

bar

After finishing the ceiling job, fill gap between flange and ceiling with

caulk or other sealant to prevent air leakage.

Ceiling

Remove the screws

the screws

Blower system

Lamp base

Remove

Aero Pure AP80RVL

Lamp base

Wing nut

Wire Panel