Aktakom ATK-2001 Kullanıcı Kılavuzu - Sayfa 8

Ölçüm Cihazları Aktakom ATK-2001 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Aktakom ATK-2001 11 sayfaları. Clamp meter

button is pushed, the current reading is set to zero and a zero symbol shall be

displayed on LCD. All the subsequent measurement shall be displayed as a

relative value with respect to the value being zeroed. Press the zero button again

to return to normal mode. But this function is disabled if MAX/MIN function is

enabled. Please watch for symbol displayed on LCD.

NOTE: LCD displays relative numerical value without bargraph.

3.4. Holding the LCD Reading

Press the HOLD button, then the reading shall be hold and kept on LCD.

Press the MAX/MIN button to enable the maximum and minimum values to be

recorded and updated during measurement. Push the button once, the

maximum value shall be displayed and updated. The LCD display toggles

between the MAX and MIN values. To exit MAX/MIN function, press and hold

the MAX/MIN button for more than 2 seconds. The Zero/Relative function will be

disabled if MAX/MIN function is enabled.

The meter will turn itself off 15 minutes after power-on (A symbol of APO is

displayed in LCD). Users can press HOLD button to turn the power on again.

Or turn the rotary switch to OFF and wait for 3 sec., then turn the rotary switch to

one of the measurement ranges to turn the power on again. Also pressing any

button or turning the rotary switch will reset the 15 minute timer.

To disable the Auto-Power-Off function, hold the HOLD button while turning on

power.

Press ZERO button for 2 sec. to enable or disable Auto-Power-Off function

(APO).