DoorHan Sectional-DIY-500 Kurulum ve Kullanım Kılavuzu - Sayfa 9
Kapı Açıcı DoorHan Sectional-DIY-500 için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. DoorHan Sectional-DIY-500 20 sayfaları. Operator
Sayfayı Yazdır
Preparation
Block the carriage.
Turn on power, the indicator of the operator will light, sound signal will be heard.
If programming has not been completed, the settings will not be stored. If there is a mistake in one of the settings, you can
turn off power and reprogram.
UPPER DOOR POSITION
+
S
S
-
P
P
Press and hold
After the sound
the key "P" for
signal you'll see "1"
about 5 sec
on the display
A setting will be stored only when you program the UPPER door position. The upper position shall be programmed before
setting of the lower door position.
Press the "–"
The "2" will light
Press the "–"
The "2" will light
A setting will be stored only when you program the LOWER door position.
AUTOMATIC FORCE SETUP
Press the "–" and
Press the "P" and
the "3" will light
the "3" will blink
Press the "–" and
Press the "P" and
the "3" will light
the "3" will blink
After the automatic force setup is performed, programming can be completed, as all other parameters have factory settings. To
finish programming, pressing the "+", select the menu "1", press "P" and hold it unless the "0" appears on the display.
FORCE LIMIT SETUP
The operator has a default setting of sensitivity level 4. Usually the user doesn't need to change this setting.
"4" will light up, you
Press the "–"
should press "P"
again
+
+
S
-
-
P
Press "P", the "1"
will blink
Press the "P" and
the "2" will blink
Press the "P" and
the "2" will blink
The leaf will move
up automatically
The leaf will move
up automatically
By pressing "–",
you should set
the required sensitivity
on the assumption that
the more dots are
displayed, the less
force sensitivity
S
+
-
P
Pressing "+" for opening or "–" for closing of the door, put the leaf in
the required opening position and press the "P" for storing
Pressing "+" for opening or "–" for closing of the door, put the leaf in
the required closing position and press the "P" for storing
Pressing "+" for opening or "–" for closing of the door, put the leaf in
the required closing position and press the "P" for storing
After the door stops in open position, press the "P", press the "P" again
and the leaf will start to close, after it stops, press the "P" for storing
After the door stops in open position, press the "P", press the "P" again
and the leaf will start to close, after it stops, press the "P" for storing
Factory setting
From low to high sensitivity
Door operation can fail, if the set
sensitivity is too high.
ELECTRICAL CONNECTIONS
S
P
You should press
"P" to store the
information
+
-
9