Asus RT-N12B1 Manuel - Sayfa 2

Kablosuz Yönlendirici Asus RT-N12B1 için çevrimiçi göz atın veya pdf Manuel indirin. Asus RT-N12B1 5 sayfaları.

A1, B1, C1 Installation

Minimum supported builds are in Supported_Devices. After the initial installation, newer DD-WRT builds

can be used, see Where do I download firmware? for more info. Note that version 36330 mini has been tested

on the A1 hardware version see [1]

dd-wrt.v24-14929_NEWD-2_K2.6_mini_RT-N12.trx

•

Reference Thread

dd-wrt.v24-17990_NEWD-2_K2.6_mini_RT-N12B1.trx

•

Reference Thread

dd-wrt.v24-18774_NEWD-2_K2.6_mini_RT-N12C1.trx

WARNING: This is only for the original RT-N12 [A1], B1, and C1 revisions. Read the Peacock

announcement.

•

If you have issues, try a different browser, restart it, or clear your cache

Download the appropriate firmware for your hardware revision

Connect only the PC with an ethernet cable to a router LAN port.

♦

Disable all other network and wireless adapters, and disconnect other cables

Set the PC to a static IP in the same subnet as the router, e.g. 192.168.1.10, subnet mask

255.255.255.0

Unplug the power connector from the back of the router.

Put the router into Recovery Mode.

Use the Asus Firmware Restoration Utility (or any TFTP client) to upload the DD-WRT mini-asus.trx

file

•

DO NOT DISTURB THE ROUTER or PC FOR THE NEXT FIVE MINUTES. BE PATIENT!

After the upgrade, the Utility should ask for a router reboot. WAIT another minute then unplug the

power.

Plug back in after 10sec, then after boot, access DD-WRT at 192.168.1.1, set a password and

configure

Set the network adapter properties for TCP/IP back automatic DHCP (IP/DNS)

A1, B1, C1 Installation

Asus_RT-N12