Anderson Oper-SRB Kullanım Kılavuzu - Sayfa 3

Brülör Anderson Oper-SRB için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Anderson Oper-SRB 12 sayfaları.

This manual has been written for those who are already familiar with all aspects of nozzle

mix burner and its add-on components. Main contents of the manual including safety rules,

burner

installation,

troubleshooting, spare parts, etc.

Disclaimer Notice

Anderson Thermal Solutions (Suzhou) Co., Ltd. reserves the right to change the

construction and/or configuation of our product at any time without informing customers.

If the product or its individual modules are used for purposes other than the designated

purpose, their effectiveness and suitability must be confirmed.

Anderson warrants that the product itself will not infringe any patents. Every effort has

been made to make this manual as accurate and complete as possible. If you find errors or

omissions, please contact us so we can correct

Due to negligence, breach of warranty or other reasons, Anderson's liability for its products

is limited to the provision of such replacement parts and will not be liable for any other

injury, loss or expense, whether direct or indirect, including but not limited to Loss of or

damage to the use of materials that sell, install, use, fail to use or repair or replace Anderson

Only those who were trained and qualified person can follow the manual to operate or

adjust the combustion system. The fire was prohibited within a radius of 5 meters of the

combustion system. Flame, non–covered light sources or heat sources shall not be brought

to the combustion area unless it is related to the process. Welding in combustion control

area shall be approved to ensure the safety in the area and also preventive measures

should be taken into consideration.

Before starting, the operator must confirm whether the burner and gas pipeline are in

normal working condition, and there is no flammable substance around the burner. The

burner must be operated with fuel and oxygen or air. The ignition and operation of the

burner must be performed at the specified position. The burner has been correctly and

safely installed before ignition. The ignition of the burner needs to be performed after the

combustion chamber is purged. If it is ignited at a low temperature, it needs to be replaced

with 5 times the volume of the combustion chamber to avoid explosion.

However, it is not necessary to purge when the temperature is higher than 750°C. Air pipe

or gas pipe connected with burner should be tight enough with no leakage, also the

periodically check air or fuel nozzles of the burners to prevent to be blocked by dust, slag

or other materials.

Anderson Thermal Soluions（Suzhou）Co., Ltd

Anderson Thermal Solutions – SRB burner Operation Manual

commissioning,

operation

parameters,

them.

maintenance

and