3M G5 Teknik Bülten - Sayfa 8

Kulaklıklar 3M G5 için çevrimiçi göz atın veya pdf Teknik Bülten indirin. 3M G5 12 sayfaları. Drive-thru systems
Ayrıca 3M G5 için: Hızlı Referans Kılavuzu (2 sayfalar), Teknik Bülten (6 sayfalar), Teknik Bülten (2 sayfalar), Manuel (10 sayfalar), Hızlı Başlangıç Kılavuzu (3 sayfalar), Manuel (8 sayfalar)

3M Graphics Warranties

3M™ Drive-Thru Systems

Timer Greet Event

The Timer Greet Event is extracted from the XT-1 Basestation using any one of the following procedures.

a. Using TALK and GND on the XT-1 Basestation

b. Using a combination of XT-1 Basestation's

• TALK and GND

• 3rd Detector Relay on top of the XT-1 Basestation and

• The Auxiliary Relay #3 and it's COM

c. Using XT-1 Basestation's Menu Board Speaker terminals (MEN SKR+ and MEN SKR-)

To extract the Greet Event from the G5 Basestation, connect the wires from the Timer system to GPIO11 and GND1

as illustrated.

IMPORTANT NOTE

GENERAL PURPOSE INPUT/OUTPUTS (GPIOs):

The G5 Basestation provides 16 configurable logical Inputs and Outputs.

All Inputs and Outputs are Active Low and are factory set to the following signals in the table above.

You can reassign any of these GPIOs to output or take as input a different signal via Digital IO Setup in the

System Menu.

To Timer System

Technical Bulletin #161 Release B