Constellation audio Inspiration INTEGRATED 1.0 Kullanıcı El Kitabı - Sayfa 12

Amplifikatör Constellation audio Inspiration INTEGRATED 1.0 için çevrimiçi göz atın veya pdf Kullanıcı El Kitabı indirin. Constellation audio Inspiration INTEGRATED 1.0 16 sayfaları.

Sayfayı Yazdır

Control screens

Many functions of the Inspiration Integrated are controlled through the LCD touchscreen.

Here is how the control screens function:

Standby

This screen appears if you touch the touchscreen when the rear-panel master

power switch is flipped up. Pushing the onscreen Power button (or the Standby

button on the remote) will power up the Inspiration Integrated and put it into

warmup mode.

Powering on

This screen appears after you press the onscreen Power button or the Standby

button on the remote while the Inspiration Integrated is powered down. It indi-

cates that the Inspiration Integrated is in warmup mode. No buttons will func-

tion when this screen appears. After about 10 seconds, the Inspiration Integrated

will become active and an input screen will appear.

Powering off

This screen appears for about 10 seconds if you push the Standby button under

the middle of the front touchscreen or on the remote while the Inspiration Inte-

grated is powered on. It indicates that the amplifier is powering off and going

into Standby mode. No buttons will function when the screen appears.

Input selector (Home)

This screen appears when the power is on and the unit is warmed up. Touching

any input button onscreen will switch to that input. The setup screen can be ac-

cessed from this screen using the multifunction button below the display.

Volume/balance

When you select an input, this screen will appear. It provides a large volume

display as well as the display for the balance control. The balance control

functions only when this screen is shown. Pushing the multifunction button

under the Setup label enters the input setup screen.

Note that when the input screen is displayed, the output of the Inspiration

Integrated can be set for speakers or headphones. The fourth indicator on the

lower part of the touchscreen (identified by the red arrow in the screen at right)

shows whether speakers or headphones are selected.