DataApex Shimadzu LC-10 Manuel - Sayfa 13

Su Pompası DataApex Shimadzu LC-10 için çevrimiçi göz atın veya pdf Manuel indirin. DataApex Shimadzu LC-10 19 sayfaları. Metal free pump

Shimadzu LC-10/20 Pump

Idle State

An item specifying the overall flow rate through the column outside the

instrument method. The following options are possible:

Pump Off

The flow rates of all components are zero.

Caution:

Be careful as this setting may damage the column in some cases.

Initial

The flow rate is defined by the first row of the gradient table (the Initial

row).

Standby

The flow rate is the same as in the STANDBY mode and, accordingly,

corresponds to the value entered in Standby Flow field.

The IDLE state comes into effect each time an Instrument is opened, at the

end or after abortion of an analysis by the Abort command, and is also

maintained after the Clarity program is shut down.

The mixing ratio of individual components in both the IDLE and STANDBY

states is given by the first row of the Gradient Table (the Initial row).

Note:

There is a step change in the flow and components percentage from the

values specified for the STANDBY state to those specified for the IDLE

state if the Idle State field is not set to Standby.

4 Using the control module

- 9 -