ADENDORFF MCll00 Kullanım Kılavuzu - Sayfa 10

Torna Tezgahı ADENDORFF MCll00 için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. ADENDORFF MCll00 18 sayfaları. Variable speed wood lathe

Sayfayı Yazdır

Erecting the leg set (Figure 2)

1. Attach one front and one back leg [1] to the

outside edge of the top plate [2] using

carriage bolts [3], washers [4], and nuts [SJ.

2. Posrtion the top plate so that it fits inside the legs.

3. Repeat step 1 for the opposite side.

4. Attach long supports [6] to legs us:ng

carriage bolts, washers and nuts.

5. Attach short supports [7] to legs using

carriage bolts, washers, and nuts.

6. Place the stand on a level surface and tighten

all nuts securely using a 14 mm wrench or

adjustable wrench.

Setting the lathe on the leg set (Figure 3)

1. Place the lathe bed assembly (1] on the leg set.

2. Position the headstock [2] assembly over the

top plate and align the holes in the bed [3]

with the holes jn the top plate [4]. Set the

headstock down carefully.

3. Align the tailsto:ck assembly end of the lathe

over the .top plate mounting holes and set it

down carefully.

4. Insert the hex bolts [5] into the mounting

holes in each bed and into the top plate.

5. Thread washer [6] and nut [7] onto bolt [5].

and tighten securely.

IMPORTANT:

THE LEG SET MUST BE FASTENED TO THE SUPPORTING SURFACE.

Head lock handle (Figure 4)

1. Locate and assemble the head locking

handle [1 ], spring [2] and bolt [3] as shown.

2. Thread assembled handle into the head

locking clamp [4] and tighten.

NOTE:

Spring loaded handles

The spring loaded handles on the lathe

are designed to minimize interference with other

Jathe parts or the workpiece.To operate,

push the handle lever in and tum clockwise to

tighten. Releasing the handle lever will

disengage the threaded shaft, allowing you to

reposition the lever handle so it is out of the way.

VI • Assembly

Fi g . 2

2-----1 1

Fi g . 3

•

Fig. 4