HighPoint SSD7110 Kurulum Kılavuzu - Sayfa 2
Bilgisayar Donanımı HighPoint SSD7110 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. HighPoint SSD7110 9 sayfaları. Macos installation
Ayrıca HighPoint SSD7110 için: Nasıl Kurulur (6 sayfalar), Kurulum Kılavuzu (8 sayfalar)
SSD7110 Controller Windows Installation Guide
1 Overview
The purpose of this document is to provide clear instructions on how to install and use
SSD7110 Controller on Windows system.
2 Installing Windows on SSD7110 controller
If you would like to install Windows onto drives attached to SSD7110 controller, please
perform the following operations:
Step 1 Prepare Your Hardware for Installation
After you attach your NVMe SSD to SSD7110 controller, you can use SSD7110 UEFI Utility to
configure your NVMe SSD as RAID arrays, or just use them as single disks.
Before installation, you must remove all the disk drives, which are not physically attached to
SSD7110 controller, from your system.
Note
SSD7110 only support UEFI boot .
the SSD7110 controller UEFI will be loaded firstly. If not, try to move it to another PCI slot.
Otherwise you may be unable to boot up your system.
Step 2 Check System UEFI Settings
Set UEFI setting with SuperMicro X11DAi-N motherboard as an example.
a.
Set "Boot Mode Select" to "UEFI";
b. And "Advanced->PCIe/PCI/PnP Configuration->CPU Slot PCI-E OPROM" to "EFI".Suppose
If you have other SCSI adapters installed, you must make sure
2/9