HighPoint SSD7110 Посібник з монтажу - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник з монтажу для Комп'ютерне обладнання HighPoint SSD7110. HighPoint SSD7110 9 сторінок. Macos installation
Також для HighPoint SSD7110: Як встановити (6 сторінок), Посібник з монтажу (8 сторінок)

Друкувати сторінку

SSD7110 Controller Windows Installation Guide

1 Overview

The purpose of this document is to provide clear instructions on how to install and use

SSD7110 Controller on Windows system.

2 Installing Windows on SSD7110 controller

If you would like to install Windows onto drives attached to SSD7110 controller, please

perform the following operations:

Step 1 Prepare Your Hardware for Installation

After you attach your NVMe SSD to SSD7110 controller, you can use SSD7110 UEFI Utility to

configure your NVMe SSD as RAID arrays, or just use them as single disks.

Before installation, you must remove all the disk drives, which are not physically attached to

SSD7110 controller, from your system.

Note

SSD7110 only support UEFI boot .

the SSD7110 controller UEFI will be loaded firstly. If not, try to move it to another PCI slot.

Otherwise you may be unable to boot up your system.

Step 2 Check System UEFI Settings

Set UEFI setting with SuperMicro X11DAi-N motherboard as an example.

Set "Boot Mode Select" to "UEFI";

b. And "Advanced->PCIe/PCI/PnP Configuration->CPU Slot PCI-E OPROM" to "EFI".Suppose

If you have other SCSI adapters installed, you must make sure

2/9