AGS Parksafe Control Panel Kurulum ve Kullanım Kılavuzu - Sayfa 8

Kontrol Paneli AGS Parksafe Control Panel için çevrimiçi göz atın veya pdf Kurulum ve Kullanım Kılavuzu indirin. AGS Parksafe Control Panel 16 sayfaları. Ventilation control panel
Ayrıca AGS Parksafe Control Panel için: Kurulum ve Kullanım Kılavuzu (16 sayfalar), Kurulum Operasyon ve Bakım (16 sayfalar), Kurulum, Çalıştırma ve Bakım Kılavuzu (20 sayfalar)

Installation & Operation Manual

Creating a Detector Chain

Up to 16 Parksafe Detectors can be connected, chained in a parallel 'daisy chain' method up to

approx. 500 yards from the panel depending on chain configuration, wire type for power and

condition. Any other way may cause issues or damage to the overall system.

Remember to individually ID each connected detector by configuring the ID switches on the circuit

boards. Make a plan and/or map of the location of all detectors for tracing and locality purposes.

It is recommended that the cable of same color should be used to connect all [D+] terminals

together and similarly cable of same color to be used to connect all [D-] terminals together.

**Split chain example.

**Where connections may exceed 500 yards from one control panel – contact your supplier!

Remember to ID your detector!

Signal communication issues may occur where the bus length is too long, high baud rates are used

or signal reflections are occurring. To avoid this, terminating at each end of a chain may help the

quality of the data signal by turning on the 120ohm terminal resistor switch.

Split chain

For more information refer to your Parksafe detector manual.

On the front display circuit board you'll find a SETTINGS switch – when switched on, the screen will

display the settings menu – you can now configure your Parksafe system.

When changes have been made – turn the settings switch off and the panel will restart!

AGS Parksafe Panel - IOM Iss: 6 10-20

**Single chain example

Single chain

Parksafe