Fujitsu ETERNUS DX100 S3 Kurulum Kılavuzu - Sayfa 5

Depolama Fujitsu ETERNUS DX100 S3 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Fujitsu ETERNUS DX100 S3 15 sayfaları. Hybrid storage systems, all-flash arrays, power synchronized unit
Ayrıca Fujitsu ETERNUS DX100 S3 için: Yapılandırma Kılavuzu Sunucu Bağlantısı (12 sayfalar), Yapılandırma Kılavuzu Sunucu Bağlantısı (12 sayfalar), Yapılandırma Kılavuzu (28 sayfalar), Yapılandırma Kılavuzu (13 sayfalar), Güvenlik Önlemleri (12 sayfalar)

Install and fasten the high-density drive enclosure in the rack, and then attach the front cover.

Attach the cable management arm in the rear.

M5 screws

Front cover

(Rack pillar: front)

IMPORTANT

Cable Connection

STEP

Various cables need to be connected to the ports on the rear of the ETERNUS DX.

Configuration Guide (Basic)

●

Point

●

IMPORTANT

●

FUJITSU Storage ETERNUS DX100 S3/DX200 S3 Hybrid Storage Systems Setup Guide

M5 screws

For safety and stability, use a lifter to install or remove high-density drive enclosures in the rack.

To help with cable management and prevent incorrect connection, attach labels to the cables and make a

note of connection origins and destinations.

This step describes dual controller type as an example. Note that there is only controller 0 (CM#0) for single

controller type.

The cables should never be bent, twisted or pulled.

Some cables have static-sensitive electronic components. Wear an anti-static wrist strap or touch a metal

part to discharge the static electricity on your body before starting each operation. Failure to discharge static

electricity before touching the connectors may cause a device failure.

(Rack pillar: rear)

Cable

management arm

P3AM-7852-06ENZ0