Fujitsu SK-96390-100PMC Kullanıcı Kılavuzu - Sayfa 27

Anakart Fujitsu SK-96390-100PMC için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Fujitsu SK-96390-100PMC 32 sayfaları. Mb96300 series

4) After programming the Flash-device, switch off the power supply and set back the

mode according to the usage of the application, e.g.:

DIP-Switch S2

(RUN Mode)

5) Power on the board. The user application is started directly.

4.2 Synchronous Mode

In order to program the Flash-ROM synchronously special third-party soft- and hardware has

to be used, e.g. GALEP-4 from www.conitec.de. This tool is not available for free.

A dedicated Flash programming socket (X17) is provided on the evaluation-board for direct

connection to this programmer.

X17: Flash programming socket

SK-96390-100PMC User Guide

Chapter 4 Programming the internal Flash memory

MD0 MD1 MD2 nc

Figure 4-1: Flash Programming Socket

- 27 -

OFF

n/c 1

2 P10_3

MD0 3

4 n/c

RST 5

6 SIN2

SOT2 7

8 SCK2

VCC 9

10 GND

UG-960017-11