Avnet Zynq Mini-ITX Manuel - Sayfa 8

Anakart Avnet Zynq Mini-ITX için çevrimiçi göz atın veya pdf Manuel indirin. Avnet Zynq Mini-ITX 11 sayfaları. Development board arm pjtag interface

Running the Reference Design on the Zynq Mini-ITX Board

 Copy the content of your microSD card to your hard drive so that you can restore

the microSD card content that was shipped with your Zynq Mini-ITX board.

Delete the content of the microSD card.

 Copy the ready_to_download/boot.bin file to the root directory of the microSD

card.

 Set the Zynq Mini-ITX board PS mode switch (SW7) for SD card boot with

"Independent JTAG". This means the SW7 positions 1-5 must be set to 10110.

 Insert the microSD card into the microSD card socket located on the Zynq Mini-

ITX board (J4).

 Power up the board (SW12) and let the microSD card configure the PL (blue

DONE LED next to the PCIe slot will be illuminated).

 Once PL is configured, U-Boot will begin to run in Tera Term terminal (at this

time PS-to-PL level shifters are enabled). Hit the return key to stop the auto-boot.

You should see the following in the Tera Term terminal.

 The ARM PJTAG interface is now ready to be used by the ARM DSTREAM.