Avnet Zynq Mini-ITX Manuel - Sayfa 9

Anakart Avnet Zynq Mini-ITX için çevrimiçi göz atın veya pdf Manuel indirin. Avnet Zynq Mini-ITX 11 sayfaları. Development board arm pjtag interface

Setting up the Host PC

This section describes how to install the USB drivers on the host PC for the USB-

UART connection to the Zynq Mini-ITX board.

8.1

Install the USB UART Drivers

Download and install the Silicon Laboratories CP210x VCP drivers on the host

computer. The drivers are available for download at

http://www.silabs.com/products/mcu/Pages/USBtoUARTBridgeVCPDrivers.aspx

8.2

Configure the Host Computer COM Port

The Reference design uses a terminal program to communicate between the host

computer and the Mini-ITX board. To configure the host computer COM port for this

purpose:

1. Connect the Mini-ITX board to the host computer via the J7 USB-UART port

and power up the board.

2. Open the host computer Device Manage as shown in the following figure. In

the Windows task bar, click Start, click Control Panel, and then click Device

Manager.

3. Open UART properties. Expand Ports (COM & LPT), right-click Silicon Labs

CP210x USB to UART Bridge, and then click Properties.