Dell PowerEdge 2650 Kurulum Kılavuzu - Sayfa 14

Sunucu Dell PowerEdge 2650 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Dell PowerEdge 2650 20 sayfaları. Activating the integrated raid controller
Ayrıca Dell PowerEdge 2650 için: Kurulum Kılavuzu (26 sayfalar), Kurulum Kılavuzu (32 sayfalar), Bilgi Güncellemesi (14 sayfalar), Kurulum Kılavuzu (40 sayfalar), Değiştirme Kılavuzu (28 sayfalar), Talimatlar Kılavuzu (8 sayfalar), Manuel (42 sayfalar), Manuel (15 sayfalar), Manuel (42 sayfalar)

F i g u r e 1 - 5 .

I n s t a l l a t i o n

shoulder washer

(2 per bracket)

mounting

flange

Holding the left slide assembly into position in the two-post rack at the location you

marked, adjust the extended back bracket tightly against the vertical two-post rack and

secure it with three 12-24 x 0.5-inch pan-head Phillips screws (see Figure 1-6).

Secure the front bracket on the slide assembly to the two-post rail with two

12-24 x 0.5- inch pan-head Phillips screws (see Figure 1-6).

Perform steps 7 and 8 to install the right slide assembly in the rack.

Use an 11/32-inch wrench or nut driver to fully tighten the nuts on the mounting

brackets on both slide assemblies that you tightened with your fingers.

Install the stiffening bracket between the slide assemblies and secure the bracket with

a 12-24 0.5-inch pan-head Phillips screw on each slide assembly (see Figure 1-6).

If the vertical rack is 3 inches wide, use the holes at the back end of the slide

assemblies (shown in Figure 1-6). If the vertical rack is 6 inches wide, use the holes

located 3 inches in front of the holes at the back end of the slide assemblies.

1-10

2-Pos t Rack Installation

R o t a t i n g t h e F r o n t M o u n t i n g B r a c k e t f o r F l u s h - M o u n t

nut (2 per bracket)

12-24 x 0.5-inch pan-head Phillips screws

(remove 2 per bracket)

NOTE: These screws are shown reinstalled on

the other slide assembly.