Award PPS863BS SI Kullanım Kılavuzu - Sayfa 9

Havalandırma Davlumbazı Award PPS863BS SI için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Award PPS863BS SI 12 sayfaları.

USE

Button

Led

Fixed

Flashing When this is activated, it signals the Activated Charcoal Filter saturation alarm,

Control panel

Function

Turns the lights on/off at maximum strength.

Turns the motor on/off at speed one.

Turns the Motor on at speed two.

Press and hold the button for approximately 3 seconds, with all the loads turned

off (Motor and Lights), to turn the Activated Charcoal Filter alarm on. The

relevant LED flashes twice to confirm.

To turn the alarm off, press the button again and hold for at least 3 seconds. The

relevant LED flashes once.

Turns the Motor on at speed three.

Press and hold the button for approximately 3 seconds, with all the loads turned

off (Motor and Lights), to perform a reset of Filter saturation alarm. The LED S1

flashes three times.

Turns the Motor on at INTENSIVE Speed.

This speed is timed to run for 6 minutes. At the end of this time, the system

returns automatically to the speed that was set before. If it is activated with the

motor turned off, the hood will switch to OFF at the end of the time.

Press and hold for 3 seconds to enable the remote control, indicated by the LED

flashing twice.

Press and hold for 3 seconds to disable the remote control, indicated by the LED

flashing just once.

Signals the Metal Grease Filter saturation alarm, indicating that it is necessary to

wash the filters. The alarm is triggered after the Hood has been in operation for

100 working hours. (Reset see the parag. Maintenance)

indicating that the filter must be changed; the Metal Grease Filters must also be

washed. The Activated Charcoal Filter saturation alarm comes

into operation after the Hood has been working for 200 hours. (Activation and

Reset see the parag. Maintenance)