Award PPS863BS SI Kullanım Kılavuzu - Sayfa 7

Havalandırma Davlumbazı Award PPS863BS SI için çevrimiçi göz atın veya pdf Kullanım Kılavuzu indirin. Award PPS863BS SI 12 sayfaları.

INSTALLATION

BEFORE FITTING THE HOOD TO THE WALL UNIT, PROCEED AS FOLLOWS:

• Open the suction panel by turning the specific knob.

• Disconnect the panel from the hood canopy by sliding the

fixing pin lever.

• Remove grease filters.

• Disconnect the wires to the Commands at the connectors.

• Disconnect the wires to the Light at the connectors.

• Remove the frame by un-

fastening the 6 screws.

• The Hood can be installed directly on the

underside of the wall unit.

• Create an opening in the bottom of the wall

unit, as shown.

• Insert the hood until the side supports snap into

place.

• Fasten using the 10 screws 12a provided.

• Lock in position by tightening the screws Vf

from underneath the hood.

• Screw the Frame back into place using the 6 screws removed as described above, re-connect

the wires to the Commands and Light, replace the metal grease filter and the Panel.

Fitting the Hood canopy