Allo RemoteControl SOMMER 4050 Talimatlar - Sayfa 2

Uzaktan Kumanda Allo RemoteControl SOMMER 4050 için çevrimiçi göz atın veya pdf Talimatlar indirin. Allo RemoteControl SOMMER 4050 2 sayfaları.

Sayfayı Yazdır
Receiver-based programming:
1. Disconnect your receiver. It is located next
to your motor.
2. Open the casing of your receiver
3. On the receiver circuit board (2), connect the
remote control as indicated in the diagram
above (1). The LED on the receiver lights up
(4).
4. Press the button you wish to program on
your new remote control (3). Keep it pressed
down. The LED light on the receiver turns
off. Release the button.
5. Wait 10 seconds
6. Your new remote control is programmed
Visit our Website: www.Alloremotecontrol.com
Visit our Website: www.Alloremotecontol.com
Visit our Website: www.Alloremotecontrol.com