Cinetech BSF HYDRA CLEAN Kullanım ve Bakım Kılavuzu - Sayfa 8

Ultrasonik Mücevher Temizleyici Cinetech BSF HYDRA CLEAN için çevrimiçi göz atın veya pdf Kullanım ve Bakım Kılavuzu indirin. Cinetech BSF HYDRA CLEAN 20 sayfaları. Motion picture film cleaner

Sayfayı Yazdır

MACHINE OPERATION

Changing film format

The rollers of the BSF HYDRA CLEAN are designed to handle either 35mm, 8/16mm or 65/70mm film

formats (depending on the options ordered).

Each Stainless Steel roller is retained by a metric hex screw and washer which can be unscrewed to

allow the roller to be removed and replaced with one of an alternate film format.

The main reel locking nuts (large aluminium hex nuts) are reversable to accommodate either 35 or

16mm cores.

Film solvent

The fluid reservoir is located on the left hand side of the machine. Remove the screw cap on the

reservoir and carefully fill with Isopar G solvent. Be careful not to overfill the reservoir and be careful not

to spill. If spillage does occur, wipe up the spill immediately with a damp (water soaked) rag and dispose

of properly.

If the machine produces a warning "SOLVENT TIMEOUT – TOP UP AND PRESS RETRY", then feed

reservoir needs a top-up. The warning will clear once the solvent level is sufficient.

For highest cleaning performance always use fresh solvent, clean PTRs (particle transfer rollers) and

new buffers.

Pre-run checks

Examine the buffers and solvent for contaminants, and wipe or wash the PTRs before cleaning each film

or when dirty.

Follow the film path through the machine, starting with the feed (left hand side) spindle and check all

rollers and PTRs are clean and spinning freely. Check the "soft-touch" pacer roller to see that it is clean.

Check that the two tension arms are moving freely (note that they are sprung loaded).

G = GUIDING ROLLER, P = PTR (PARTICLE TRANSFER ROLLER), B = BUFFER ROLLER, A = SOLVENT

APPLICATION ROLLER, T = TRANSFER ROLLER

Page 8 of 20