Cisco 2960-C Kurulum Kılavuzu - Sayfa 3

Anahtar Cisco 2960-C için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Cisco 2960-C 37 sayfaları.
Ayrıca Cisco 2960-C için: Başlangıç Kılavuzu (25 sayfalar)

Sayfayı Yazdır

Chapter 2

Switch Installation

For connections outside the building where the equipment is installed, the following ports must be

Warning

connected through an approved network termination unit with integral circuit protection: 10/100/1000

Ethernet. Statement 1044

To prevent the system from overheating, do not operate it in an area that exceeds the maximum

Warning

recommended ambient temperature of: 113°F (45°C)

Statement 1047

Note

No user-serviceable parts inside. Do not open. Statement 1073

Warning

Installation of the equipment must comply with local and national electrical codes. Statement 1074

Warning

To prevent airflow restriction, allow clearance around the ventilation openings to be at least:

3 in. (7.6 cm) Statement 1076

Warning

Hot surface. Statement 1079

Note

Installation Guidelines

Before installing the switch, these guidelines must be met:

•

OL-23803-02

For Catalyst 3560CG-8PC-S, 3560CG-8TC-S, and 2960CG-8TC-L switches, the maximum

recommended ambient temperature is: 104°F (40°C).

Applies to the Catalyst 3560CG-8PC-S switch.

The operating environment must be within the ranges listed in

Specifications."

Cabling is away from sources of electrical noise, such as radios, power lines, and fluorescent

lighting fixtures. Make sure that the cabling is away from other devices that might damage the

cables.

Airflow around the switch and through the vents must be unrestricted. We strongly recommend that

you allow at least 3 in. (7.6 cm) of clearance from the left, right, and top sides of the switch to avoid

any flow blockage. If you are installing the switch in a rack, allow at least 1.75 in.

(4 cm) of empty rack space above each switch.

Catalyst 3560CG-8PC-S, 2960C-8PC-L, 2960C-12PC-L, 3560C-8PC-S, and 3560C-12PC-S

switches: Allow at least 1.75 in. (4 cm) clearance from the ends of the external heat sink fins.

Catalyst 3560-C and 2960-C Switch Hardware Installation Guide

Preparing for Installation

Appendix A, "Technical

2-3