Cisco 3750 - Catalyst EMI Switch Başlangıç Kılavuzu - Sayfa 20

Anahtar Cisco 3750 - Catalyst EMI Switch için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Cisco 3750 - Catalyst EMI Switch 33 sayfaları. Catalyst 3750 series switches
Ayrıca Cisco 3750 - Catalyst EMI Switch için: Veri Sayfası (18 sayfalar), Kurulum Manüelleri (47 sayfalar), SSS (10 sayfalar), Ürün Bülteni (5 sayfalar), Ürün Destek Bülteni (6 sayfalar), Ürüne Genel Bakış (25 sayfalar), Açıklama (1 sayfalar), Veri Sayfası (23 sayfalar), Ürün Destek Bülteni (6 sayfalar), Başlangıç Kılavuzu (27 sayfalar), Veri Sayfası (23 sayfalar)

Sayfayı Yazdır

Cisco 3750 - Catalyst EMI Switch Başlangıç Kılavuzu

Install the SFP Modules and Connect to the Ports

Follow these steps:

Grasp the module on the sides, and

Step 1

insert it into the switch slot until you

feel the connector snap into place.

Insert an appropriate cable into the

Step 2

module port. Insert the other cable

end into the other device.

For a list of supported modules, see the release notes on Cisco.com. For detailed instructions on

installing, removing, and connecting to SFP modules, see the documentation that came with the

SFP module.

Removing and installing an SFP module can shorten its useful life. Do not remove and

Caution

insert SFP modules more often than is absolutely necessary.

Verify Port Connectivity

After you connect to the switch port, the port LED turns amber while the switch establishes a link.

This process takes about 30 seconds. Then the LED turns green when the switch and the target device

have an established link. If the LED is off, the target device might not be turned on, there might be a

cable problem, or there might be a problem with the adapter installed in the target device. See the "In

Case of Difficulty" section on page 22 for information about online assistance.

13 X

14 X

SFP module

13 X

14 X

SFP module port

C a ta ly st 3

7 5 0 G

SE RI ES

P o E -2 4

23 X

2 5

2 7

2 6

24 X

2 8