Cisco 3750 - Catalyst EMI Switch Başlangıç Kılavuzu - Sayfa 21

Anahtar Cisco 3750 - Catalyst EMI Switch için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Cisco 3750 - Catalyst EMI Switch 33 sayfaları. Catalyst 3750 series switches
Ayrıca Cisco 3750 - Catalyst EMI Switch için: Veri Sayfası (18 sayfalar), Kurulum Manüelleri (47 sayfalar), SSS (10 sayfalar), Ürün Bülteni (5 sayfalar), Ürün Destek Bülteni (6 sayfalar), Ürüne Genel Bakış (25 sayfalar), Açıklama (1 sayfalar), Veri Sayfası (23 sayfalar), Ürün Destek Bülteni (6 sayfalar), Başlangıç Kılavuzu (27 sayfalar), Veri Sayfası (23 sayfalar)

Install the XENPAK Module and Connect to the Ports

Follow these steps to install

Catalyst 3750G-16TD switch:

Step 1

Remove the two Phillips-head

retaining screws from the XENPAK

module slot cover, and store them for

later use. Remove the cover.

Step 2

Align the XENPAK module with the

guide rails inside the module slot, and

slide the module into the slot until the

XENPAK faceplate is flush with the

switch faceplate.

Step 3

Secure the XENPAK module in place by tightening the two captive installation screws.

Do not overtighten the screws.

Step 4

Remove the rubber plugs from the XENPAK module ports and fiber-optic cable, and

store them for future use.

Step 5

Align the cable SC connector with the

XENPAK module connector, so that

transmit (TX) meets receive (RX),

and RX meets TX.

See the "Verify Port Connectivity" section on page 20 for instructions on how to verify that the

XENPAK module ports have established a link to the external device.

a XENPAK module into the XENPAK module slot on the front panel of the

Rubber

XENPAK

plug

module

C at al ys t 37

se rie s

C at al ys t 37

se rie s

C a ta ly st 3

7 5 0

se ri es

T X

R X

XENPAK

module