Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Kurulum Notu - Sayfa 22

Anahtar Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion için çevrimiçi göz atın veya pdf Kurulum Notu indirin. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 46 sayfaları. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Ayrıca Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion için: Kurulum Notu (14 sayfalar), Çözüm Kılavuzu (17 sayfalar), Beyaz Kitap (19 sayfalar), Açıklama (1 sayfalar), Ürün Bülteni (6 sayfalar), Uyarı (4 sayfalar), Veri Sayfası (9 sayfalar), Veri Sayfası (18 sayfalar), Beyaz Kitap (18 sayfalar), Yapılandırma Kılavuzu (8 sayfalar), Kurulum Notu (28 sayfalar), Sorun Giderme Kılavuzu (11 sayfalar), Kurulum Notu (18 sayfalar), Kullanıcı Kılavuzu (17 sayfalar), Kurulum Notu (24 sayfalar), Manuel (19 sayfalar), Kurulum Notu (36 sayfalar)

Upgrading the Ethernet Module Memory

Figure 12

Step 5

Immediately place the old memory module in an antistatic bag to protect it from ESD damage.

Installing the 1-GB Memory Module Upgrade

Memory modules have sensitive components that are susceptible to ESD damage. To prevent ESD

Caution

damage, handle memory modules by the edges only; avoid touching the memory chips, pins, or traces

(the metal fingers along the connector edge of the SODIMM). (See

To install the 1-GB memory module on the Ethernet module, follow these steps:

Step 1

Verify that an ESD grounding strap is still securely attached to your wrist and to a proper earth ground.

If you are unsure about the correct way to attach an ESD grounding strap, refer to the

ESD Grounding Strap" section on page 42

Step 2

Remove the 1-GB memory module from the antistatic shipping bag.

Step 3

Hold the sides of the 1-GB memory module between your thumbs and forefingers with the component

side up and with the connector edge (the metal fingers) facing away from you. (See

Tilt the 1-GB memory module to approximately the same angle as the socket, and insert the connector

Step 4

edge of the memory module into the socket.

When inserting the memory module, use firm but not excessive pressure. If you damage a socket, you

Caution

will have to return the Ethernet module to the factory for repair.

Press the front edge of the 1-GB memory module down until both spring clips on the socket engage the

Step 5

sides of the memory module securing the memory module in place. (See

Catalyst 6500 Series Distributed Forwarding Card 3 for WS-X67xx Modules Installation Note

Handling a Memory Module

Figure

for instructions.

12.)

"Attaching Your

Figure

12.)

Figure

13.)

78-15893-08