Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Kurulum Notu - Sayfa 24

Anahtar Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion için çevrimiçi göz atın veya pdf Kurulum Notu indirin. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 46 sayfaları. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Ayrıca Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion için: Kurulum Notu (14 sayfalar), Çözüm Kılavuzu (17 sayfalar), Beyaz Kitap (19 sayfalar), Açıklama (1 sayfalar), Ürün Bülteni (6 sayfalar), Uyarı (4 sayfalar), Veri Sayfası (9 sayfalar), Veri Sayfası (18 sayfalar), Beyaz Kitap (18 sayfalar), Yapılandırma Kılavuzu (8 sayfalar), Kurulum Notu (28 sayfalar), Sorun Giderme Kılavuzu (11 sayfalar), Kurulum Notu (18 sayfalar), Kullanıcı Kılavuzu (17 sayfalar), Kurulum Notu (24 sayfalar), Manuel (19 sayfalar), Kurulum Notu (36 sayfalar)

Installing the DFC3B and DFC3C Daughter Cards

Installing the DFC3B, DFC3BXL, DFC3C, and DFC3CXL Daughter Cards on

Ethernet Modules without Stiffener Brackets

During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly

Warning

touch the backplane with your hand or any metal tool, or you could shock yourself. Statement 94

To install the DFC daughter cards on Ethernet modules that do not have stiffener brackets, follow these

steps:

Step 1

Attach an ESD grounding strap to your wrist and to ground.

If you are unsure about the correct way to attach an ESD grounding strap, refer to the

ESD Grounding Strap" section on page 42

Step 2

Remove the new DFC3 daughter card from the antistatic bag and the installation hardware from the

packaging.

Note

Align the mounting holes on the DFC3 daughter card (see

Step 3

module. (See

aligned with the remaining standoffs on the module.

Figure 14

Catalyst 6500 Series Distributed Forwarding Card 3 for WS-X67xx Modules Installation Note

The DFC3 daughter card is designed to be installed on different modules; therefore, there may

be more mounting holes on the DFC3 daughter card than there are standoffs on the module. Not

all mounting holes on the DFC3 daughter card are used in all installations. Visually verify that

there are standoffs beneath the mounting holes before installing the installation hardware.

Figure

15.) Make sure that the remaining mounting holes on the DFC3 daughter card are

Mounting Holes on the DFC3 Daughter Card

for instructions.

Figure

Align with the male standoffs

on the module

"Attaching Your

14) with the male standoffs on the

78-15893-08