Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Manuel - Sayfa 15

Anahtar Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion için çevrimiçi göz atın veya pdf Manuel indirin. Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion 19 sayfaları. Distributed forwarding card 4 for ws-x68xx, ws-x69xx, and select ws-x67xx modules
Ayrıca Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion için: Kurulum Notu (14 sayfalar), Çözüm Kılavuzu (17 sayfalar), Kurulum Notu (46 sayfalar), Beyaz Kitap (19 sayfalar), Açıklama (1 sayfalar), Ürün Bülteni (6 sayfalar), Uyarı (4 sayfalar), Veri Sayfası (9 sayfalar), Veri Sayfası (18 sayfalar), Beyaz Kitap (18 sayfalar), Yapılandırma Kılavuzu (8 sayfalar), Kurulum Notu (28 sayfalar), Sorun Giderme Kılavuzu (11 sayfalar), Kurulum Notu (18 sayfalar), Kullanıcı Kılavuzu (17 sayfalar), Kurulum Notu (24 sayfalar), Kurulum Notu (36 sayfalar)

Sayfayı Yazdır
Cisco 6500 - Catalyst Series 10 Gigabit EN Interface Module Expansion Manuel
Cisco - Connecting a Terminal to the Console Port on Catalyst Switches
Pinouts
Pin
Signal
1
RTS
Output
2
DTR
Output
3
TXD
Output
4
Ground
5
Ground
6
RXD
Input
7
DSR
Input
8
CTS
Input
Catalyst 6000/6500 Supervisor Engine I, II and 720
Console Port Signals and Pinouts
The Catalyst 6000/6500 family switch comes with an accessory kit that contains the cable and adapters
you need to connect a console (an ASCII terminal or a PC running terminal emulation software) or
modem to the console port. The accessory kit includes these items:
RJ-45-to-RJ-45 rollover cable
RJ-45-to-DB-9 female DTE adapter (labeled "Terminal")
RJ-45-to-DB-25 female DTE adapter (labeled "Terminal")
RJ-45-to-DB-25 male DCE adapter (labeled "Modem")
These are the same cable and adapters that ship with the Cisco 2500 series routers and other Cisco
products.

Console Port Mode Switch

The Supervisor Engine front-panel console port mode switch allows you to connect a terminal or modem
to the console port as follows:
Note: Use a ball-point pen tip or other small, pointed object to access the console port mode switch. The
switch is shipped in the in position.
Mode 1: Switch is in the in position. Use this mode to connect a terminal to the console port using
the RJ-45-to-RJ-45 rollover cable and the data terminal equipment (DTE) adapter (labeled
"Terminal"). You may also use this mode to connect a modem to the console port using the
RJ-45-to-RJ-45 rollover cable and the data communications equipment (DCE) adapter (labeled
"Modem"). See
http://www.cisco.com/warp/public/473/9.html (15 of 19) [9/4/2003 12:36:03 PM]
Direction
Request To Send
Data Terminal Ready
Transmit Data
Receive Data
Data Set Ready
Clear To Send
Console Port Mode 1 Signaling and
Description
Pinouts.