Cisco 6160 Kurulum Prosedürleri Kılavuzu - Sayfa 12

Ağ Donanımı Cisco 6160 için çevrimiçi göz atın veya pdf Kurulum Prosedürleri Kılavuzu indirin. Cisco 6160 32 sayfaları. Without a pots splitter configuration
Ayrıca Cisco 6160 için: Hızlı Referans Kılavuzu (38 sayfalar), Donanım Kurulum Kılavuzu (21 sayfalar), Montaj ve Değiştirme Notları (18 sayfalar)

Installation Procedures

4.2.5 Attach the Cisco 6160 Power Connections

Caution

To prevent the system from powering up, do not install the fuses at this time. If the fuses are already

installed in the fuse and alarm panel, remove them. You can replace the fuses after the system is installed

and connected.

For full power redundancy, each terminal block must be connected to a separate power source. If you do

Note

not require power redundancy, you can wire a single terminal block, or connect both terminal blocks to

a single power source.

Do not power the components in the rack by chaining them together.

Warning

The illustration shows the DC power supply terminal block. Wire the DC power supply as illustrated.

The proper wiring sequence is ground to ground, positive to positive, and negative to negative. The

ground wire must always be connected first and disconnected last. The fuse and alarm panel and

wires are not provided by Cisco.

Complete the following steps to connect power to the system:

Verify that power in the DC circuit is off.

Step 1

Identify the correct power terminal block on the backplane of the Cisco 6160. The PWR 1 connector is

Step 2

used if you have a primary PEM installed in the chassis. The PWR 2 connector is used if you have a

secondary (redundant) PEM installed in the chassis.

PWR 2 power terminal block connectors.

Step 3

Use a flat-head screwdriver and a counterclockwise motion to open the positive and negative terminal

connectors on the power terminal block.This step ensures that the correct opening is presented for the

wires. (See

Figure 4-8

Correct terminal

position (open)

Cisco 6160 Hardware Installation Guide

4-12

Figure

4-8.)

Positioning the Power and Ground Terminals to Accept Wires

Incorrect terminal

position (closed)

Chapter 4

Installing a Cisco 6160 Without a POTS Splitter Configuration

Figure 4-4

shows the location of the PWR 1 and

OL-2190-02 B0