Cisco 6160 Kurulum Prosedürleri Kılavuzu - Sayfa 17

Ağ Donanımı Cisco 6160 için çevrimiçi göz atın veya pdf Kurulum Prosedürleri Kılavuzu indirin. Cisco 6160 32 sayfaları. Without a pots splitter configuration
Ayrıca Cisco 6160 için: Hızlı Referans Kılavuzu (38 sayfalar), Donanım Kurulum Kılavuzu (21 sayfalar), Montaj ve Değiştirme Notları (18 sayfalar)

Chapter 4

Installing a Cisco 6160 Without a POTS Splitter Configuration

For more information on a subtended network configuration, see the

Note

Configuration" section on page

The term subtending refers to the host chassis, and subtended refers to the downstream chassis in a

subtended network.

Cisco does not provide the cables for the subtending connections. See

4.2.10.1 DS3 Subtending Connections

Complete the following steps to connect the DS3 subtending connections:

For more information about DS3 subtending connections, see the

Note

with DS3/2DS3 or OC-3c/2DS3 NI-2 Cards" section on page

Step 1

Verify that the DS3/2DS3 or OC-3c/2DS3 NI-2 card is installed in slot 10 (or slot 11, if a secondary NI-2

card is installed for redundancy) of the Cisco 6160 chassis to ensure that the DS3 NI-2 card connections

are active.

Note

On the subtending host chassis backplane, attach one end of a coaxial cable to the TX BNC connector

Step 2

for DS3 Port 2 on the I/O card.

Note

OL-2190-02 B0

1-6.

See the

"Redundancy in Subtended Configurations" section on page 1-42

about redundant configurations.

See

Table 2-4

for cable specifications. See

locations.

"Subtended Network

Table 2-4

"Subtended Network Configuration

1-9.

Figure 1-19

Figure 1-23

Cisco 6160 Hardware Installation Guide

Installation Procedures

for cable specifications.

for more information

for DS3 port connector

4-17