Cisco 6160 설치 절차 매뉴얼 - 페이지 17

{카테고리_이름} Cisco 6160에 대한 설치 절차 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 6160 32 페이지. Without a pots splitter configuration
Cisco 6160에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (38 페이지), 하드웨어 설치 매뉴얼 (21 페이지), 설치 및 교체 참고 사항 (18 페이지)

페이지 인쇄

Chapter 4

Installing a Cisco 6160 Without a POTS Splitter Configuration

For more information on a subtended network configuration, see the

Note

Configuration" section on page

The term subtending refers to the host chassis, and subtended refers to the downstream chassis in a

subtended network.

Cisco does not provide the cables for the subtending connections. See

4.2.10.1 DS3 Subtending Connections

Complete the following steps to connect the DS3 subtending connections:

For more information about DS3 subtending connections, see the

Note

with DS3/2DS3 or OC-3c/2DS3 NI-2 Cards" section on page

Step 1

Verify that the DS3/2DS3 or OC-3c/2DS3 NI-2 card is installed in slot 10 (or slot 11, if a secondary NI-2

card is installed for redundancy) of the Cisco 6160 chassis to ensure that the DS3 NI-2 card connections

are active.

Note

On the subtending host chassis backplane, attach one end of a coaxial cable to the TX BNC connector

Step 2

for DS3 Port 2 on the I/O card.

Note

OL-2190-02 B0

1-6.

See the

"Redundancy in Subtended Configurations" section on page 1-42

about redundant configurations.

See

Table 2-4

for cable specifications. See

locations.

"Subtended Network

Table 2-4

"Subtended Network Configuration

1-9.

Figure 1-19

Figure 1-23

Cisco 6160 Hardware Installation Guide

Installation Procedures

for cable specifications.

for more information

for DS3 port connector

4-17