Cisco Firepower 2130 Kurulum ve Bakım - Sayfa 20

Sunucu Cisco Firepower 2130 için çevrimiçi göz atın veya pdf Kurulum ve Bakım indirin. Cisco Firepower 2130 26 sayfaları. Rack-mount and ground the chassis
Ayrıca Cisco Firepower 2130 için: Manuel (12 sayfalar), Dağıtım Kılavuzu (8 sayfalar), Başlarken (42 sayfalar)

Sayfayı Yazdır

Install the FIPS Opacity Shield in a Two-Post Rack

If the system is powered on, listen for the fans. You should immediately hear the fans operating. If you do not hear the

fans, make sure the fan tray is inserted completely into the chassis and the faceplate is flush with the outside surface of

the chassis.

Step 6

Verify that the fan is operational by checking the fan tray LED. See

Install the FIPS Opacity Shield in a Two-Post Rack

Note

Caution

You need the following to install the FIPS opacity shield:

• #1 Phillips screwdriver

• The following items from the FIPS kit:

Note

Step 1

Copy the serial number and store in a secure place. To find the serial number, see

Step 2

Perform the steps described in

bracket (Step 2).

Step 3

Connect the cables to the ports. Make sure that the cables have enough slack to route them through the cable mounting

brackets.

Installation, Maintenance, and Upgrade

Because the FIPS opacity shield covers the serial number on the chassis, the Crypto Officer (CO) should copy

the serial number and store it in a secure place. The serial number is needed when you call Cisco TAC.

This procedure should be performed only by the CO.

• One FIPS opacity shield

• Four 8-32 x 0.375-inch Phillips screws used to attach the FIPS opacity shield to the cable management

brackets

• Seven Tamper Evidence Labels (TEL)

The TELs are made of a special thin gauge vinyl with self-adhesive backing.

Once the CO attaches them on the chassis, any attempt to open the chassis damages

the TELs or the chassis cover. Because the TELs have nonrepeated serial numbers,

the CO can inspect them for damage and compare them against the applied serial

numbers to verify whether the chassis has been tampered with. TELs with curled

corners, rips, and slices indicate tampering. The word "FIPS" or "OPEN" may

appear if the label has been peeled back.

Rack-Mount the Chassis Using Brackets

Installation, Maintenance, and Upgrade

Front Panel LEDs

for a description of the fan LEDs.

Serial Number

including installing the cable management

Location.